home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
QRZ! Ham Radio 13
/
QRZ Ham Radio Callsign Database - Volume 13.iso
/
modfiles
/
th28_1.txt
< prev
next >
Wrap
Text File
|
1999-04-07
|
1KB
|
34 lines
Subject: Kenwood TH28 Mod
To transfer memories from one radio to another,you can clone two TH-28a's.
Each radio must either have the ME-1 installed or no ME-1 installed,but they
both must be the same!
Radio A will be the radio that SENDS the memories!
Radio B will receive the memories!
1.Turn on Radio B and enter say 144MHZ into all the memories you are going to
CLONE TO.
2.Say radio A has 125 memories,enter 144MHZ into 125 of radio B's memories.
This ENABLES or turns ON radio B's memories.
3.Turn both radios off then on.
4.Enter a simplex frequency into both radios and make sure you use the VFO
mode.
5.Turn on radio A while pushing button 7 at the same time,the display should
read"CLONE".
6.Turn on radio B while pushing button 7 at the same time,the display should
read"CLONE".
7.Press PTT or push-to-talk on radio A!
8.You will hear tones on both radios which go real fast and vary in pitch.
9.Leave the radios for about 15-20 minutes so they can finish.
10.The tones will be repititous-this will indicate the transfer was successful.
11.Turn off radio A,you might hafto disconnect the battery.
12.Turn off radio B,then check the memories.
This does work,I tried it myself 125 memory transfer in 15 minutes PL's,odd
offsets and all.Call channel is not transferred!If this does not work,try a
few times.
Special thanks to N2OUM and N2PPT!
73 DE N2PPV